WIRE-JST-FEMALE: JST Female on 150mm lead

150mm long power lead fitted with JST female connector. 22AWG wire. Recommended maximum current 5A.

WIRE-JST-MALE: JST Male on 150mm lead

150mm long power lead fitted with JST male connector. 22AWG wire. Recommended maximum current 5A.

WIRE-SERVO-EXT-300: 24AWG Servo extention lead, 300mm

Fitted with a male and female 3 pin servo connector, these 300mm long extension leads are very useful for when you need to move that servo down the wings or tail a bit further. 24AWG.

WIRE-SERVO-FM-150: Servo socket lead, 150mm, female

150mm long servo type lead with female socket. Ideal for making small extensions or repairing existing devices

MAGNET-5x5x1-N45: 5x5x1mm N45 magnet (single unit)

We have these strong magnets in stock primarily for the purpose of hatch magnets or control-rod connectors. Some people have used these for CDR type brushless motors, though we have never used them for that ourselves.

• 5 x 5 x 1 mm
• Triple coated
• Nickel finished
• N45 Rated
• GAUSS 2100

For planes like the QFII, we recommend 4 magnets (at the rear) combined with a 2mm CF rod offcut at the front.
The Seether requires at least 10 magnets (4 rear, 4 middle, 2 front).

PLD-VP220: PLD Voltage protector 220uF

Suitable for two (2) 9g servo configurations

Assist in stopping short lived but trouble making voltage dips. Glitches are especially bad for modern DSP and microcontroller enabled receivers. Tiny, lightweight insurance.

laminatingfilm15x300: Laminating film 38~42 micron (1.5mil) x 270-330mm (per metre)

Please note the width of this film can vary between 270mm and 330mm depending on currently available stocks.

laminatingfilm30x300: Laminating film, 30 micons (1.1mil) x 300mm (per metre)

This 30 micron laminating film is very special. Compared to the 38~40 micron film it's considerably lighter and requires only a very low iron temperature to activate the glue. The film itself is more flexible than the thicker varieties allowing it to be used on those compound curves.

CONN-JST-XH3: JST XH3 type connector (single unit)

These connectors are used for plugging balancing plugs on lipos into.

This is a 3 pin connector, suitable for 2S packs

CONN-JST-XH4: JST XH4 type connector (each)

These connectors are used for plugging balancing plugs on lipos into.
With these connectors you can make up balancing leads for your lipos to fit into your own chargers (if supported).

This is a 4 pin connector, suitable for 3S packs.